Jamie Oliver Home Instrucciones De Uso página 4

INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your barbecue and causing injury to yourself and to
property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with the regulator.
4. Turn all of the control knobs to the 'OFF' position before turning on the gas supply to the appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR BARBECUE
1. Open the lid before lighting.
2. Connect the gas cylinder to the barbecue following the instructions supplied with the regulator.
3. Turn all the control knobs to the 'OFF' position.
4. Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator connection and operating
instructions. Check the cylinder to regulator connection and hose to barbecue hose inlet connection for leakage using
soapy water. Any leakage will show as bubbles in the area of the leak. If leak is found, do not use the barbecue.
Consult your gas or barbecue supplier for advice.
5. To light the left hand burner, push down and turn the left burner control knob anti-clockwise to the 90° position (full
rate position). An audible click will be heard, this should light the burner. Check that the burner is alight. If the burner
has not lit, repeat this process.
6. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes before retrying the ignition
sequence.
7. When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-clockwise to any
position between the full and low rate position.
8. Light the remaining burners from left to right in sequence.
9. To turn 'OFF' the barbecue, turn the cylinder valve handle or regulator switch to the 'OFF' position by following the
regulator instructions. Once the burners have extinguished turn all the control knobs to the 'OFF' position.
Warning: If any burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off.
Wait five minutes before attempting to relight with ignition sequence.
Side burner lighting instructions (
1. Once the grill burner has been lit, the side burner can be lit by following the instructions below.
2. Open the side burner lid before lighting the side burner and turn the side burner control knob to the 'OFF' position.
3. Push down the side burner control knob and keep pressing whilst turning anti-clockwise to the full rate position, an
audible click will be heard, this will light the burner. If the burner does not light, repeat this process.
4. If the burner has not lit after two attempts, turn off the gas tap, wait 5 minutes and then repeat step 3 in main burner
lighting instructions.
5. When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-clockwise to any
position between the full and low rate position.
6. To turn the barbecue 'OFF' , turn the cylinder valve or regulator switch to the 'OFF' position and then turn all of the
control knobs on the appliance clockwise to the 'OFF' position when the flame have extinguished.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off. Wait
five minutes before attempting to relight with ignition sequence.
All manuals and user guides at all-guides.com
Lighting Instructions: Main Burners
If applicable)
: