Elexa Level mount DSK30DJ Manual Del Usuario página 13

Montaje/Instalación
Figure 11
Arm
Plate
Cord
Management
Monitor
Monitor
Bracket
Desk Top
Monitor
Monitor onitor
Bracket acket
Desk Desk
Figure 14
Desk Top Arm
Cord Cover
Cord Cover
Cord Cover
L-Bracket
Cords
All manuals and user guides at all-guides.com
Step 4 – (Continued)
Built-in Bubble Built-in Bubble
Level/ Level/
The Arm Plate has a Built-in Bubble Level/Spirit Level to ensure the Flat Panel
Spirit Level p p
Monitor is level when attached to the Desktop Arm. The Cord Management
hook at the bottom of the Arm Plate, gathers the cords from the Flat Panel
Monitor to feed through the Cord Cover as shown in Figure 11.
Lift the Flat Panel Monitor with the Flat Panel Bracket attached, higher than
the Arm Plate, which is attached to the Desktop Arm. Place the back of the
Flat Panel Bracket over the Arm Plate and slide the Flat Panel Bracket down
until it clicks together with the Arm Plate as shown in Figure 12.
The Flat Panel Bracket secured to the Arm Plate and Desktop Arm appears as
shown in Figure 13.
Figure 12
Bubble
Level
Arm Plate
Cord
Management
Desk Top
Arm
Figure 13
Arm
Plate
Desk Top
Arm
Step 5 – Organizing Monitor Cords
To organize and hide the Flat Panel Monitor's cords, slide the bottom two
sections of Cord Cover down off the back of the Desktop Arm as shown in
Figure 14 (The top section remains in place). Feed the cords from the Flat Panel
Monitor into the hollow of the Desk Top Arm. When cords are in place, slide the
two sections previously removed back up into the channels of the Desk Top
Arm, starting with the cut-out scoop then the straight section. Push up until the
cut-out section meets the top section of Cord Cover.
Cord Cover
Sections
13
www.levelmount.com
1-888-229-1459
EU: +0044 844 567 2657
UK: 0844 567 2657
©2011 Level Mount - Patents Pending