tiki Cabos Manual De Instrucciones página 3

Extinguishing:
1. Using the metal Snuffer that is provided, carefully place completely over Wick
until flame is extinguished – DO NOT BLOW OUT (see FIG 6).
Note: Leave the Snuffer on the Torch to prevent water contamination.
Note: If the Fuel becomes contaminated with water, the Wick
and Fuel must be replaced and properly disposed of in
accordance with local laws and regulations.
Refilling:
1. Remove the Fuel Canister.
2. Unscrew the wick holder from fuel canister.
3. Fill the Decorative Fuel Canister to 1/2 inch (13 mm) below seam with
TIKI Brand Torch Fuel – DO NOT OVERFILL. (see FIG 4)
®
4. Wipe away any spilled fuel before lighting.
5. Reattach the Wick Holder to the Fuel Canister
(see FIG 3). DO NOT OVERTIGHTEN.
6. Replace the Fuel Canister.
7. Allow Wick to become saturated with fuel before lighting.
Wick Replacement:
1. Carefully remove the Wick from the Wick Holder. (see FIG
7). Properly dispose of the Wick in accordance with local
laws and regulations.
2. Replace the Wick with a new TIKI
position the Wick with 3/4 inch exposed. (see FIG 8).
3. Trim as required.
Storage:
1. Store Fuel in original Fuel Bottle with Cap secured
2. Dispose of any unwanted Fuel in accordance to local laws
and regulations.
2. Store upright in a dry location (see FIG 9).
3. For best results, store product away from the weather conditions
when not in use.
Cleaning:
1. When not in use, use a damp cloth to remove debris from
the Decorative Vessel as needed.
All manuals and user guides at all-guides.com
Torch Wick and
®
3 3
3/4 inch (19mm)
1" (25 mm)
FIG 8
09/16
FIG 6
FIG 7
Proper
Wick
Position
FIG 9
4000059