Operating Elements And Connections; Safety Notes - IMG STAGELINE VU-800/SW Manual De Instrucciones

VU Meter
These instructions are intended for users without any specific
technical knowledge . Please read these instructions carefully
prior to operation and keep them for later reference . All op-
erating elements and connections de scribed can be found on
the fold-out page 3 .

1 Operating Elements and Connections

1 Trimming controls for sensitivity adjustment of the left and
the right channel
2 Selector switch for the display mode of the LEDs (3):
BAR = bargraph display, DOT = dot display
3 LED level display; indicating the level for the left channel
(upper row) and the right channel (lower row) in dB
4 Power switch
5 Low voltage jack for connecting the power supply unit pro-
vided
6 Stereo input AUDIO IN for connecting the output of the
signal source whose level is to be indicated (e . g . mixer,
effect unit)
7 Stereo feed-through output AUDIO OUT for connecting the
input of a subsequent unit (e . g . amplifier, second mixer,
tape unit)
All manuals and user guides at all-guides.com

2 Safety Notes

The units (VU meter and power supply unit) correspond to
all relevant directives of the EU and are therefore marked
with .
WARNING The power supply unit uses dangerous mains
voltage . Leave servicing to skilled personnel
only . Inexpert handling of the unit may result
in electric shock .
•
The units are suitable for indoor use only . Protect them
against dripping water and splash water, high air humidity
and heat (admissible ambient temperature range 0 – 40 °C) .
•
Do not place any vessels filled with liquid on the units, e . g .
drinking glasses .
•
Do not operate the VU meter and immediately disconnect
the power supply unit from the mains socket:
1 . if there is visible damage to the VU meter or to the power
supply unit .
2 . if a defect might have occurred after a unit was dropped
or suffered a similar accident .
3 . if malfunctions occur .
In any case, the units must be repaired by authorized per-
sonnel .
7