Hahnel Captur Manual página 7

All manuals and user guides at all-guides.com
BULB Mode
Select BULB mode on camera. Press and hold the
to open the shutter - after 3secs timer LED
Release Button
flashes red = . Full press
shutter. For more advanced timed BULB shooting use the
and settings.
Interval Timer Programmable Functions
Press
Start/Stop
Photography'. The Captur Module - Timer will now take a
photo continuously at the factory set interval time. Press
again to 'Stop' the interval timed photography.
Start/Stop
The values of the following parameters can be adjusted as
required. Use
Toggle Button
the parameters which need to be adjusted. Press SET button
to adjusted parameters.
14
to adjust the value of the parameters. Press SET button
again to confirm adjustment.
Parameters Description
Delay before 1st shutter
3
is released
Burst/Bulb time
4
1st Interval Time
5
6
shots for 1st Interval
times
repeated
2nd Interval Time
7
Digital Channel Matching – DCM
a. Timer - Press and hold
flash green
b. Receiver - Press and hold button + Turn 'ON'. LED will show
steady red
c. DCM is complete. Turn both Timer & Receiver 'OFF' and
'ON' to reboot
Note: For multiple Receivers repeat step 'b' for all receivers without
turning off timer
Camera & Flash Remote Control
Requires an additional Captur receiver and Transmitter which
are synced on a differnet channel.
Captur - Timer Kit
Release Button
button to 'Start' the 'Interval Timed
< or > to move between
15
Toggle Button
= Number of
= Number of
program is
Release Button
= to close
+ or - is used
15
14
Setting
0s to max 99hrs 59'min
59"s (in 1s increments)
1s to max 99hrs 59'min
59"s (in 1s increments)
1 to 999 and ---
(unlimited)
1s to max 99hrs 59'min
59"s (in 1s increments)
+ Turn 'ON'. LED will
7