König Electronic TVS-KN-MOT10B Manual De Uso página 3

All manuals and user guides at all-guides.com
Drill the mounting holes with a 10 mm masonry bit to at least 60 mm depth. Insert a concrete anchor (T) into each of these
holes and then lighten the lag bolts (V) into the concrete anchor (T), leave 5 mm stand out of the wall.
b. Hardwood wall mounting:
Use a high quality stud sensor to locate three adjacent studs. It is a good idea to vertify where the studs are located
with an awl or thin nail shown in diagram. Drill a 3 mm deep hole at the desired height in each stud using a 4mm drill bit.
Tighten the lag bolts (V) into each mounting hole until 5 mm standing out of the wall.
Note: Do not use any concrete anchor (T) when you mount the motorized wall mount onto a hard wood wall.
3.
Fasten the lag bolts after the motorized wall mount (A) is mounted level.
4.
Fasten the screw after paralleling the wall plate and the LCD TV.
5.
Fasten the screw after paralleling the wall plate and the LCD TV.
3