1byone O00QH-0504 Manual Del Usuario página 2

www.1byone.com
Wireless door chime kits user manual
All doorchime with Easy Chime Logo working together
Thank you for purchasing 1Byone wireless door chime receiver, before use, please read carefully the
following use instructions. Failure to do so may render your guarantee void.
Package contents
- 1×Receiver
- 1×User manual
- 1×Wall plugs
- 1×Screws
Features
with adjustable speaker volume
Visual Blue LED indicator to assist the hard of hearing with visual notice of ring signal (User Selectable)
with 3 selectable operation modes:
-Bell only
-Blue LED light only
-Bell and Blue LED light simultaneously
36 polyphonic melodies for the selection.
Specifications
RF frequency: 433MHz
Transmitting range: 300 feet in the open air
Sound level (Typical): 80dB
Power Supplier
2×1.5V AA batteries (not included)
1. Loud speaker
2. Blue LED indicator
3.Wall mounting hole
4.Volume High/Medium/Low
5.Sound-and-Flash Switch
6.melodies selecting
7.Code-matching button
All manuals and user guides at all-guides.com
SKU: O00QH-0504
3
4
5
6
7
1
2
1
Getting started
Receiver is powered by 2×1.5V AA batteries(not included)
Open the battery compartment cover,insert 2 new batteries observing the correct polarity.
Note: To replace the batteries,remove the used batteries from battery compartment and re-insert
the new batteries,observing the correct polarity.
Important Note :
1) If you do not plan to use the device for a long time, such as at a vacation,please remove the battery
from the chime (receiver) and push button(transmitter) ,then put them in a safe place.
2) Improperly using a battery may cause it to leak and damage nearby items, and can create the risk of
fire and personal injury. Batteries should not be left in an area where the children can reach them as
they may pose a chocking hazard.
3) Recycle used batteries following environmental protection practices.
Operating
Matching the units
All doorchime with Easy Chime logo can work with this receiver together, one feature of this function is
both receiver and transmitter can match each other automatically.
After inserting the batteries of receiver and transmitter, press the push button, this will send a signal to the
receiver and will automatically register and memorise the signal as an operation code.
1 transmitter can work with unlimited receivers, 1 receiver can work with 5 transmitter max.
1.If there is interference from another electronic device,your operation above not working,remove the
batteries and re-insert after 1 minute,press the code matching button,then press the push button.
2. If your transmitter is missing,you can buy the only Transmitter from store with Easy Chime logo and
operate with the same way above.
3. Iff adding a transmitter or receiver,press the matching code button,the press the push button.
Testing the units
Before final installation, verify the receiver can work with transmitter properly.
- Selecting receiver melody
Simply press the melodies selecting button until the desired melody is played. This will becomes the
operating melody
- Adjusting the volume
Press the volume button to adjust the volume
-Selecting the mode
Press the selector to select Bell only/Blue LED light only/Bell & Blue LED light
www.1byone.com
2