Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8
Important Note: Keep in mind that the two
RCA inputs are completely independent of one
another; however these inputs should not be
used if the 1/4" analog 1 and 2 inputs are used,
as doing so may cause irreversible damage to
the Firefly. You can, however, mix and match
these inputs. If, for example, you wanted to
use RCA input 1 and 1/4" input 2 that would
not cause any problems.
10. Analog 1/4" TRS Outputs 1 and 2
This are balanced 1/4" TRS Line Outputs with
line level signal (+4dBu). Use them to get a
stereo output channel and connect them to
active monitors (such as the Phonic P8A), or
perhaps to an amplifier and a passive pair of
speakers. You could also use them with several
signal processor or any external devices.
11.
Analog RCA Outputs 1 and 2
These are RCA line outputs. They accept RCA
cables and can be connected to any external
device that uses this connector type (tape
recorders, MP3 recorders, etc.).
12.
S/PDIF In/Out
These are a standard S/PDIF Digital Audio
Input/Outputs that can be use with digital
mixers, DAT recorders, or any external device
that uses RCA Digital interface format. The
S/PDIF's output sampling rate is determined
by the sampling rate set by the Firefly control
software. Please use a 75 ohms coaxial cable
with RCA plug if you are using the S/PDIF
connection, as the most common problems
associated with glitches in digital interfaces are
the result of use of using poor quality cable.
Firefly 302
9
10
12
13
13. MIDI In/Out
You can have 16 simultaneous MIDI input/
output channels sent to and from your
computer through the Firefly 302 Plus.
14. FireWire Ports
This is a digital FireWire (a.k.a. PC IEEE 1394)
interface that you can use to connect to your
computer. Doing so allows users to send their
audio signal from the Firefly to the Computer,
and vise-versa. There are both the 4-pin and
6-pin varieties available – the difference being
the 6-pin will allow you to power the Firefly
through the Firefly connection (provided the
Power Selector Switch is set to 'BUS').
15. 9-12VDC Input Power Jack
Connect the supplied DC converter to this
jack to feed the unit. Please only use this DC
converter in order to ensure no damage is done
to the Firefly. If, for any reason, your converter
gets lost or damaged and you need a new one
please contact your local dealer. This option
lets you work on the road without draining your
laptop's battery.
16. Power Selector Switch
This switch gives users three operation options:
DC IN will turn on the Firefly using the DC input
power; PWR OFF will turn the Firefly off, and;
BUS will allow the Firefly to use Power provided
through the 6-pin FireWire connection.
14
5
6
7
Publicidad
Tabla de contenido
