X-lander round the World XQ Instrucciones De Uso página 15

All manuals and user guides at all-guides.com
14. ASSEMBLY AND DISASSEMBLY OF REAR WHEELS
To assembly or disassembly the wheel, push button, which is in the middle o f
the wheel.
15. MOUNTING OF THE FRONT WHEEL
In order to mount the wheel, slide it onto the axle until the lock is engaged.
16. DISMOUNTING OF FRONT WHEEL
In order to take the wheel off, push the button shown on the figure , and pu ll
the wheel off the axis.
17. BACKREST ADJUSTMENT
Pick up the tie and put up the backrest in required position.
18. ADJUSTING THE HANDLE HEIGHT
Push in the both buttons located on articulated joints of the handle and change
its location.
19. ADJUSTING THE LENGTH OF THE HANDLE
Pull the links of the locks and change length of the handle by sliding it out or in.
20. MOUNTING OF CARRYCOT
In order to mount the carrycot on the frame, slide its catches into mounting
seats until locks are engaged.
21. DISMOUNTING OF CARRYCOT
To take the carrycot off, push in the buttons unlocking the catches (a) and pull
it out from mounting seats (b).
22. MOUNTING THE CAR SEAT
Special adapters are needed in order to mount the baby car seat. Place the
adapters in mounting seats of the frame and attach the car seat by catching it
on the adapters.
Attention: Ensure proper fitting of the armchair before using it.
23. REMOVING THE CAR SEAT
In order to take the car seat off, push in the unlocking pushbuttons on both its
sides, while simultaneously pulling it out of mounting seats. Remove adapters
by pushing in the unlocking pushbutton.
24. INFLATING WHEELS
To inflate a wheel, unscrew the valve's cotter. Place the pump on the valve
and inflate the wheel. The maximum allowed wheel pressure is 1.5 bar.
25. PLACING AN ADDITIONAL SEAT PAD
Unfasten the straps buckle (a). Place the seat pad on the stroller's seat and
move the seatbelts through the openings as shown in (b, c). Add the shoulder
pads on the shoulder belts as shown in (d).
WARNINGS AND POINT OF ATTENTION
Based on effectuated tests, Deltim declares that the delivered stroller
complies with all requirements of PN-EN1888/2003 + A1/A2/A3:2005 norm.
12