Description (Fig. A); Assembly And Adjustments - Stanley FATMAX SFMCMW2651 Traducido De Las Instrucciones Originales

ENGLISh
Description (Fig. A)

WARNING: Never modify the area light. Damage or
personal injury could result.
ON‑OFF switch box
1
ON‑OFF button
2
Safety key
3
Main handle (Upper handle)
4
Lower handle
5
Bail handle
6
Battery cover
7
Cut height adjust lever
8
Rear door cover
9
Grass collection bag
10
11 Grass collection bag handle
Lower carrying handle
12
Side flap
13
14 Side discharge attachment
Handle height adjust levers
15
Upper handle lock levers
16
17 Upper handle knob
Intended Use
This lawn mower has been designed for consumer lawn
mowing applications.
DO NOT use under wet conditions or in the presence of
flammable liquids or gases.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.

ASSEMBLY AND ADJUSTMENTS


DANGER: To reduce the risk of serious personal
injury, turn unit off and remove the safety key and
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can cause injury.
Adjusting Handle Height (Fig. A, C)
The mower is shipped in storage mode. You will need to adjust
the handle to operating position before continuing.
1. To unlock the lower handle
open the two handle height adjust levers
height adjust levers 15 are located on both sides of the
lower handle 5 .
40
5 from the storage position,
15 . The handle
2. Raise the lower handle to the operating position. Take care
to not pinch or stress the cord.
3. Close the handle height adjust levers
lower handle into position.
NOTE: If the connection between the handle and lever is too
tight or too loose, open the lever and adjust the depth of the
lever by turning the lever clockwise or counterclockwise. Close
it again until each lever stays securely closed and the handle is
secure and will not move.
Attaching Upper Handle (Fig. A, D)
1. Line up the holes on the bottom of the upper handle
with the holes on the top of the lower handle
to not pinch or stress the cord.
NOTE: Make sure the cord is located on the front of both
handles. If it is not it may result in the cord tangling and the
inability to easily store the mower.
2. From the outside of the upper handle
lock levers 16 through the two handle holes. Repeat for the
opposite side.
3. From the inside of the upper handle loosely tighten a
knob 17 onto each handle lock lever
4. Rotate the upper handle 4
care to not pinch or stress the cord.
5. Close the handle lock levers
into position.
NOTE: If the connection between the handle and lever
is too tight or too loose, open the lever and adjust the
depth of the lever by turning the lever clockwise or
counterclockwise. Close it again until each lever stays
securely closed and the handle is secure and will not move.
Grass Collection Bag (Fig. E)

DANGER: Turn unit off and remove safety key and
battery packs.
1. Lift the rear door cover 9 and place the grass collection
bag 10 onto the mower so the bag lugs
the slots 20 on the inside plastic surfaces of the handle
brackets as shown in Fig. E. Then lower the rear door cover.
2. If installed, remove side discharge chute
side flap 13 is fully down.
Side Discharge (Fig. A, F)

DANGER: Turn unit off and remove safety key and
battery packs.
1. To operate mower in side discharge mode, remove the grass
collection bag 10 .
2. Be sure rear door cover 9
3. Lift the side flap 13 and hook side discharge chute
the mower.
4. Release the side flap and ensure the side discharge
chute 14 holds in place before turning mower on.
NOTE: The rear door cover
opening (at the bottom) cannot be completely closed off.
15 , securing the
4
5 . Take care
4 , slide the handle
16 .
into its operating position. Take
16 securing the upper handle
19 slide into
14 and make sure
is closed.
14 onto
9 is shaped in such a way that the