AIRIS LW108P Manual Del Usuario página 32

All manuals and user guides at all-guides.com
GB
Operatión
Clear program list:
You can clear the program list by clicking Clear or Clear All icon here if you are not satisfied with it.
Note: 1. As for DVD discs, such operation can only be realized when the title menu has appeared.
2. The maximum number of chapters or tracks can be programmed is 16.
3. Some discs don't support such operation.
CLR (Clear)
You can cancel the unsatisfactory or wrong number input with this button during program and search operation.
TITLE
Press this button during playback of DVD disc, a title list (depending on the disc) will appear on the monitor.
Use direction button or number button to select your preferred title then press OK button to start playing.
MENU
Press MENU button on the remote control during playback, a menu (depends on the disc) shall be displayed on
the screen.
Use the direction or number button to select your preferred item then press OK button to start playback as requi-
red. Such function is available only for DVD disc.
OK
Press this button to confirm an setting or particular operation.
DISPLAY
Press this button during playback to view the relevant information of the disc on the TV screen, e.g. elapsed time,
total time, chapter No. and playing status etc.
VIDEO OUT
Pressing this button in DVD mode will enable the switch between the video output mode COMPONENT, S-VIDEO
and RGB.
Note: These three video modes both support composite video output.
RETURN
Pressing this button will enable to get back to the Menu when VCD, SVCD disc is played with PBC function
activated.
SETUP
Press this button to bring up the OSD menu system. Once a new setting is activated, the player will run in a new
condition even after power interruption.
MODE
Press this button during playback, the sub-menu of MODE and REPEAT will appear. Use UP/DOWN button to
browse the menu and shift the options before pressing OK button to confirm.
For DVD discs, there are 2 mode options: NORMAL/ SHUFFLE and three Repeat options: SINGLE/ ALL/ OFF.
For VCD discs, there are three mode options: PBC/ NORMAL/ SHUFFLE and 3 Repeat options: SINGLE/ ALL/
Off.
Press this button again to quit current operation and proceed to other operation.
When playback stops, pressing MODE button shall enable to program the playback as well as clear preset pro-
grams.
Note: The playback mode of CD, MP3, MPEG4 discs can not be set until the disc menu appears.
VOL+/VOL-
During playback of a disc, use these two buttons to change the mains audio volume so as to control the volume
sizes of the two channels.
32