Troubleshooting Guide - Guardian Technologies Germ Guardian SD1000 Instrucciones De Uso Y Cuidado

oPEraTioN
iNSTaLLiNG or rEPLaciNG BaTTEriES
1. always make sure the power switch on the bottom of the unit is in the oFF
position before installing or replacing batteries.
2. Remove the cover of the battery compartment located on the bottom
of the unit.
3. Install 4 AAA batteries, observing proper +/- polarities as indicated inside
of the compartment.
4. Replace the cover of the battery compartment.
iMPorTaNT
To avoid accidental dispensing of liquid, it is suggested to install batteries
BEFORE filling the dispensing tank.
TiPS
1. Replace old batteries with new ones when the 'automatic dispensing' of the
product becomes noticeably weaker.
*Battery life will depend on frequency of use and thickness of liquid being dispensed.
2. If there is liquid in the unit when batteries need to be replaced, always
sure to hold down the tank cover to prevent liquid from flowing out, or remove
liquid completely and reinstall when filling is complete.
3. Remove the batteries if the unit is not going to be used for an extended
of time (ie - vacation).
aDDiNG LiQuiD To ThE DiSPENSiNG TaNK
1. Make sure the power switch on the bottom of the unit is in the OFF position.
2. Access the dispensing tank by pressing your thumb against the indent and
lifting off the tank cover.
3. Fill the dispensing tank with liquid to MAX fill line.
iMPorTaNT: Do NoT ovErFiLL DiSPENSiNG TaNK WiTh LiQuiD.
4. Replace the tank cover.
iMPorTaNT
• The dispensing tank must be over 1/8 of the way filled with liquid for the
unit to properly dispense.
• Never fill the dispensing tank above the MAX level marked on the outside
the dispensing tank, otherwise unit will not dispense liquid properly.
uSE oNLy ThE FoLLoWiNG LiQuiDS iN ThE DiSPENSiNG TaNK:
• Hand Soap
Due to varying thicknesses of liquids, the rate
• Dishwashing Soap
and quantity of dispensing will also be varied.
• Hand/Body Lotion
• Hand Sanitizer
E-4
oPEraTiNG ThE LiQuiD DiSPENSEr
1. To turn 'automatic dispensing' function ON, slide the power switch on the
bottom of the unit to the ON position.
2. Place hand under the dispensing nozzle, the built-in infrared sensor will
detect your hand and the unit will automatically dispense liquid from the
nozzle.
3. Slide the power switch to the OFF position to deactivate the 'automatic
dispensing' function.
NoTE
LED illuminating indicator (inside dispensing tank) will light up when liquid is being
dispensed.
TiP
During the first use of the Touchless Liquid Dispenser, please repeatedly activate the
'automatic dispensing' function several times until the dispensing becomes normal.
*This may also be necessary if the unit is idle for a long period of time.
make

TrouBLEShooTiNG GuiDE

period
ProBLEM
Dispenser is not working.
Liquid is not dispensing properly
or weak dispensing.
Liquid dispensing too quickly.
of
oPEraTioN (coNTD)
SoLuTioN
Replace batteries.
Turn power switch to ON position.
Replace batteries; make sure liquid added is not too
thick - should NOT be thicker than hand lotion.
Repeatedly activate the 'automatic dispensing'
function several times (See TIP page E-5).
Liquid may be too thin (see IMPORTANT page E-4 for
types of liquids to use in dispenser).
E-5