Metra Electronics Axxess Integrate AXBUCH-T1 Instrucciones De Instalación

Toyota Back-Up Camera Retain/Add-On 2012-2015
INTERFACE FEATURES
• Retains the factory back-up camera to an aftermarket radio
• Allows an aftermarket camera to be added to the factory screen*
* Display and navigation model radios only
INTERFACE COMPONENTS
• AXBUCH-T1 harness
Scion Toyota
FRS 2013-2015 4-Runner
iQ 2014-2015 (w/o factory amp) 2012-2013
tC 2014-2015 Avalon
xB 2014-2015 Camry
xD 2014-2014 Highlander
Prius
Prius PHV
TOOLS REQUIRED
• Cutting tool • Tape • Crimping tool
• Connectors (example: butt connectors, bell caps, etc.)
Integrate • AxxessInterfaces.com
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
AXBUCH-T1
INSTALLATION INSTRUCTIONS
APPLICATIONS
Prius V
Rav-4 (before build
2013-2014 date Nov. 2013)
2012-2013 Rav-4
2013 Sequoia
2012-2015 Tacoma (with NAV) 2012-2013
2012-2015
Venza
REV. 12/12/19
The AXBUCH-T1 can be connected two different ways
To retain the factory back-up camera to an aftermarket radio:
• Connect the Black wire to chassis ground.
• Connect the Yellow wire to accessory power. *
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.
• Disregard the loose Green/Purple wire, it will not be used in this application.
* It is highly recommended to use the AXCSD-6V (sold separately) to provide the camera with
the proper voltage.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the Black wire to the ground wire of the aftermarket camera.
• Connect the power wire of the aftermarket camera to accessory power.
• Tape off and disregard the Yellow wire, it will not be used in this application.
2012-2014
• Connect the female Yellow RCA jack to the aftermarket camera.
2014
The following (2) steps are only required if a wire is
2013
not present in the factory harness.
2013
*Except Avalon 2013-2014 and Venza 2013-2014
• If a wire is not present in pin-2 of the 28-pin
2013-2014
connector of the factory radio, unplug the
connector, then insert the metal pin of the
loose Green/Purple wire into it. Connect the
harness back into the radio.
• Connect the other end of the loose Green/
Purple wire to the reverse wire of the vehicle.
INSTALLATION INSTRUCTIONS
Connections to be made
14 13 12 11 10 9 8 7 6 5 4 3 2 1
28 27 26 25 24 23 22 21 20 19 18 17 16 15
This is the wire view of the connector
Integrate • AxxessInterfaces.com
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
AXBUCH-T1
28 Pin Harness
in the vehicle
REV. 12/12/19