BATTERY REPLACEMENT
Figure 3
NOTE: After several years of use, the battery
may need replacing.
1.
Remove the three screws from the top of the lamp
and remove the top from the fixture. (See Figure 3)
2. Remove the screws from the LED dome on the
underside of the top. (See Figure 4)
3. Take battery out of its secured position and unclip its
wire. Clip new battery in and reinstall lamp in reverse
order. (See Figure 5)
1. Clean solar panel regularly with a damp towel to
guarantee optimum performance.
If solar charged light does not come on at dusk, despite
observance of all the instructions, try the following:
1.
Make sure solar light is not affected by any other
light source.
2. Ensure solar light is not affected by any shade
during the day.
3. Make sure switch is in on position.
4. Check that batteries are installed correctly.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
Figure 4
For replacement battery information, contact
Uline Customer Service at 1-800-295-5510.
MAINTENANCE
TROUBLESHOOTING
WINTER TIPS:
For optimal performance, be sure to remove any snow
or debris accumulation from the solar panel. A solar
panel free of debris will charge the batteries much
more efficiently.
1-800-295-5510
uline.com
Figure 5
WARNING! Do not dispose of li-ion battery in
the regular trash, municipal waste stream or
by fire, as batteries may leak or explode. Do
not open, short circuit or mutilate batteries,
as injury may occur. Recycle li-ion batteries
or dispose of them in accordance with local,
state and federal regulations. Do not mix old
and new batteries.
NOTE: Do not use any type of solvent for
cleaning and do not to put excessive pressure
on module while cleaning.
NOTE: The performance of solar lamp will vary
with time of year. It will deliver more light when
it has a full day of direct sun rather than a day
in overcast weather.
WARNING! Keep out of reach of children.
0621 IH-7239