Alpina SF-7650 Instrucciones De Utilizacion página 3

INSTRUCTION FOR USE
ASSEMBLY
1. Nip the two bottoms on both sides of the join of the tube, insert it into the suction hole on the main body and lock
it.
2. The connection between the bended tube and the flexible drawtube or section tube. Connect the bended tube to
the drawtube (or section tube), then turn them against each other to lock them firmly. When dissembling, just turn
them in the opposite direction to the above mentioned. Figure 1
3. The connection between the drawtube and the floor brush. Connect the drawtube into the tube of the floor brush,
and then turn them against each other to lock it firmly. When dissembling, just turn them in the opposite direction
to the above mentioned. Figure 2
4. The connection of drawtube and 2-in-1 brush connect the drawtube into the 2-in-1 floor brush, and then turn them
against each other to lock it firmly. When dissembling, just turn then in the opposite direction to the above
mentioned. Figure 3
HOW TO USE YOUR VACCUM CLEANER
1. Sweeping, power cord extraction and switch: Pull out plastic tube from the trough; lay down the cleaner on the floor.
Pull out all power cord conveniently by running the front fixture. Insert the plug into electrical outlet, press ON/OFF
to start or stop the appliance.
2. The vacuum has constant suction speed and there are no adjustments for it.
3. Suction power adjusting button: For certain material, e.g. curtain, silk, woolen cloth etc. full power suction may be
too strong to use. Then you may adjust the button on the bended tube to lower down the suction power. When the
hole on the tube seems larger, the suction power is lower, while contrarily larger. Figure 1
4. Use the 2-in-1 small brush to clean the corner and the places with aperture. Figure 2
5. The usage of floor brush when cleaning floor or any hard surface: push down the button to the side marked with
"---"" When cleaning carpet, push down the button to the side marked with "" Figure 3
1
Warning:
VDE Plug
This appliance is equipped with a grounded, power supply cord. This is a safety feature. Do not attempt to defeat the
safety purpose of this plug.
BS Plug (optional)
If the product is fitted with a standard UK main outlet 3pin plug and the mains cable becomes damaged, it should be
replaced by a qualified electrician. If it is necessary to change the plug, the wiring instructions below must be followed at
all times. The fuse from the plug being replaced should be removed, as insertion into a mains supply socket would be
dangerous.
All manuals and user guides at all-guides.com
1
2
2
3
ENGLISH
3
3