Macintosh Users - SMC Networks Barricade SMC7004VWBR Guia De Inicio Rapido

Step 2... Get Connected
Connect all of the computers that you want to have share your
Internet connection. This is necessary to detect that each device
is properly connected. It is safe to connect and disconnect
Ethernet cables from your computer(s), Barricade
modem when it is turned on.
Use the diagram below to assist you with setting up your network:
Note: Please use standard Category 5 (CAT-5) Ethernet cables with RJ-45
connectors.
PDA with
Wireless Compact
Flash Card
Broadband
Modem(Cable/DSL)
Ethernet
Cables
3
™ , or broadband
Power
Adapter
To AC Wall
Outlet
To Computer
Computer One
Two
Step 3... Begin
Once you have all of your computers connected, you are ready
to install the EZ 3-Click Installation Wizard.
• Remove the CD-ROM from the box.
• If the computer is off, turn it on.
• When the computer boots up, insert the CD-ROM into the
CD-ROM drive of the computer that is connected to the
Barricade ™ .
Note: The screen shown below will appear only if the Autorun feature is
enabled. If the EZ 3-Click Installation Wizard does not start automatically,
follow the steps below to start the program:
1. Double-click the [My Computer] icon.
2. Double-click on CD-ROM or Compact Disc icon to view the
contents of the CD.
3. Click on the [EZ Install] Icon to launch the program.

Macintosh Users!

If you are setting up the Barricade
Macintosh network, please see Appendix A for specialized
directions on configuring and setting up the Barricade
manually. The EZ 3-Click Installation Wizard is not compatible
with the MacOS.
™ Router in an ALL
™
4