Publicidad
• Connect the Gray/Black wire to the right front negative speaker output of
the aftermarket radio.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker output.
The following (3) wires are for the aftermarket radios that have navigation built in.
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio (if applicable).
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio (if applicable).
• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation
radio (if applicable).
Attention! If the interface loses power for any reason, the following steps will need to
be performed again. Also, if installing an AXSWC connect it after you initialize and test
the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio
comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off
position, disconnect the interface, check all connections, reconnect the interface,
and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions
of the installation for proper operation, before reassembling the dash.
1-800-221-0932
REV. 1/21/20
AXVI-1788
INITIALIZING THE AXVI-1788
K
P
NOWLEDGE IS
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians
metraonline.com
Publicidad
