Zuvo Water Purator Manual Del Propietário página 4

Installation
Find a suitable location for the unit next to the sink and
power source where the air is breathable and free from
dust or fumes. The Zuvo Water Purator generates ozone
using the surrounding air.
1. Remove the aeration
nozzle and gasket from
the water faucet.
CAUTION: If your faucet
cannot accommodate the
diverter assembly, you
must purchase and install
an under-counter assembly.
2. Attach the diverter valve
assembly to the water
faucet. If the diverter
supplied with the unit
does not attach directly
to the faucet, install the
adapter supplied with
the unit.
Operating Instructions
IMPORTANT
The Zuvo Water Purator is not designed to operate
with hot water. Run only cool tap water through the
unit. Prior to drinking water from the unit, flush the
unit for five minutes. Do not drink water coming
from the system during this initial start-up.
To operate the unit, simply
turn on the faucet and pull
the diverter valve plunger
outward.
To bypass the unit, push
the diverter valve inward.
Page 4
All manuals and user guides at all-guides.com
You will observe the following when the unit is
operating properly:
• Once flow is established the UV lamp will turn on and
become fully bright and steady within the first second
of operation.
• Water enters the unit at the bottom where it is mixed
with air and ozone, forming a vortex of swirling
bubbles and a swooshing sound.
• Any ozone left following the patented ozone/UV
photo oxidation process is reconverted to oxygen in
the filter element. Water leaving the unit is fully
treated and mixed with air and oxygen. The air will
appear as tiny bubbles, sometimes giving the water an
initial cloudy appearance. After sitting for a minute or
so, all of the bubbles will rise to the surface and
disperse, leaving the water crystal clear.
• The ultraviolet lamp in the unit has a useful life of
thousands of on-off cycles. One cycle could be a small
cup of water or a large pitcher. To maximize the life of
the lamp, it is best to get a pitcher to store in the
refrigerator for drinking during the day, as opposed to
running it several times to draw individual glasses of
water.
• The ultraviolet lamp remains illuminated for
approximately 30 seconds after flow through the unit
has ceased. This is a design function to ensure that
water remaining in the unit between uses has been
treated and should not allow bacteria to build up in
the filter during non-use of the device.
• IMPORTANT: If the diverter pin does not remain in the
"out" position by itself, or if the UV lamp does not
activate, there could be insufficient water pressure in
your home plumbing to operate the system. (The
system requires a minimum of 20 PSI.)
When To Replace Filter
The filter should be replaced when the unit has been
in service six or more months, 500 or more gallons of
water have been processed, or the filter shows signs of
dirt build up or deterioration, evidenced by a decrease
in the rate of water flow, or a decrease in the swirling
bubble action. Replacement filters can be obtained
at www.zuvowater.com or through your authorized
supplier.