Ringer On/Off - Conairphone SW114 Manual Del Usuario

All manuals and user guides at all-guides.com

RINGER ON/OFF

Your CONAIRPHONE features a harmonic tone
ringer. When you don't want to be disturbed
slide the switch to the OFF position. Now you
can still make outgoing calls, but you will not
be disturbed by incoming calls.(see Fig. 3).
FLASH
The FLASH key can be used to retrieve a new
dial tone after ending a call. It is also a useful
feature for special telephone services such as
call waiting or three party calling. Press briefly,
release and perform the custom call procedures.
NOTE : Call waiting is a service of your local
telephone company.
MUTE
To talk to someone on your end of the phone
without the caller hearing your conversation,
press and hold the MUTE key. Release the MUTE
key to resume your conversation with the caller.
Trouble Shooting Guide
Problem: No dial tone
• Check all modular plugs to be sure they have
clicked into place.
• Is cord damaged in any way?
• Try another phone jack If your
CONAIRPHONE TM works on another jack, it is
likely that there is a problem with your wiring.
Problem: I hear my phone dialing, but I can not
get past the dial tone.
• Check the tone/pulse switch. If positioned in
Tone (T) mode, switch to Pulse (P). You may
have pulse dialing service.
10
Problem :Phone doesn't ring.
• Is ringer switch set to the "OFF" position?
• How many extensions are connected to your
line? If more than five telephones are installed
on the same line, you may need to contact your
local telephone company to determine the
maximum number of extensions for your
calling area.
Problem: The sound volume is too low.
• Is another extension off hook? If so, hang up
extension.
Hearing Aid Compatibility
TM
Your CONAIRPHONE is compatible with
inductively coupled hearing aids.
FCC WANTS YOU TO KNOW
This equipment complies with part 68 of the
FCC rules and ACTA technical requirements.
On the bottom of the base of this equipment is
a label that contains, among other information,
the Registration Number and Ringer Equiva-
lence Number (REN) for this equipment. You
must, upon request, provide this information to
your telephone company.
The USOC number of the registration jack for
the equipment is RJ11C.
The FCC compliant telephone cord and
modular plug is provided with this equipment.
This equipment is designed to be connected to
the telephone network or premises wiring
using a compatible modular jack which is
TIA/EIA-IS-968 compliant.
11
The REN is used to determine the quantity of
devices you may connect to your telephone line
and still have all of those devices ring when
your telephone number is called. In most, but
not all areas, the sum of the RENs of all
devices connected to one line should not
exceed five (5.0). To be certain of the number of
devices you may connect to your line, as
determined by the REN, you should contact
your local telephone company to determine the
maximum REN for your calling area.
If your telephone equipment causes harm to
the telephone network, the telephone company
may discontinue your service temporarily. If
possible, they will notify you in advance. But if
advance notice isn't practical, you will be notified
as soon as possible. You will be informed of your
right to file a complaint with the FCC.
Your telephone company may make make
changes in its facilities, equipment, operations,
or procedures that could affect the proper
functioning of your equipment. If they do, you
will be notified in advance to give you an
opportunity to maintain uninterrupted
telephone service. If you experience trouble
with this telephone equipment the telephone
company may ask that you disconnect this
equipment from the network until the problem
has been corrected or until you are sure that
the equipment is not malfunctioning.
This equipment may not be used on coin service
provided by the telephone company. Connection
to party lines is subject to state tariffs.
12