Beper P201UTP010 Manual Del Usuario página 9

Operation
Open the tank, by rotating it clockwise and lifting the main unit
upwards. Pour the solution to be nebulized, taking care not to
exceed the maximum fill line marked on the tank.
Attention: the solution to be nebulized must be water-
based; oily based solutions (e.g. gel, fragrance oil, etc.)
cannot be atomized, and can cause the clogging of the
atomizer.
Place the tank back into the main unit, and fix it by turning it
counterclockwise.
To turn the device on, place the operation switch on the desired
function:
INDUCTION – the device works in induction mode, nebulization will
activate only when hands or objects to be sanitized will approach
the infrared sensor;
AUTO – the device will operate in continuous mode, nebulizing the
disinfectant solution without interruptions for approx.. 4 hours (or
until the solution runs out).
When the device is operating, the blue LED indicator turns on.
To shut the device off, place the operation switch on OFF position.
Cleaning and maintenance
Disconnect the USB cable from the device before proceeding with
cleaning.
Clean the tank by rinsing it under tap water, dry thoroughly. Use a
slightly dampened, soft cloth to remove dust and stains from the
main unit.
Warning: main unit is made of aluminum alloy; do not use
abrasive sponges and/or detergents for cleaning, to avoid
damaging the surface.
To replace the cotton swab, remove the plastic cover by pulling it
towards you, making sure not to lose the small spring found inside
the plastic cover; remove the filter to be replaced and place the new
one in the same position. Replace the plastic cover by pressing to
make sure it fits snuggly inside its case.
9
EN