Troubleshooting - Black and Decker MATRIX BDCMTHD Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SCREw DRIVING
For driving fasteners, the reversing button should be pushed to the left. Use reverse (button
pushed to the right) for removing fasteners. When moving from forward to reverse, or vice
versa, always release the trigger switch first.
DRILLING
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the Safety Instructions.
• Use appropriate and required safety equipment, as instructed in the Safety Instructions.
• Secure and maintain work area, as instructed in the Safety Instructions.
• Run the drill very slowly, using light pressure, until the hole is started enough to keep the drill bit
from slipping out of it.
• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not
so much as to stall the motor or deflect the bit.
• Hold the drill firmly with two hands, one hand on the handle, and the other
gripping the bottom around the battery area.
• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT TO
START IT. DAMAGE TO THE DRILL CAN RESULT.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the last part
of the hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
• Make sure switch turns drill on and off.
DRILLING IN wOOD
Holes in wood can be made with the same twist drill bits used for metal or with spade bits. These
bits should be sharp and should be pulled out frequently when drilling to clear chips from the flutes.
DRILLING IN METAL
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which should
be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.
DRILLING IN MASONRy
Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the drill but not so
much that you crack the brittle material. A smooth, even flow of dust indicates the proper drilling rate.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
NOTE: Refer to Power Unit instruction manual for troubleshooting solutions regarding opera-
tion of the Power Unit.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
wARNING
:
The use of any accessory not recommended for use with this tool could be hazardous.
Recommended accessories for use with your tool are available from your local dealer or authorized
service center. If you need assistance regarding accessories, please call: 1-800-544-6986.

TROUBLEShOOTING

Possible Cause
• Attachment is not secured.
Possible Solution
• Make certain the attachment is fully
pushed into the Power Unit.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido