Publicidad
Idiomas disponibles
Idiomas disponibles
1. Preparation for use
Unpack the unit carefully. We recommend that you save the box and packing materials, in
case you wish to store the unit.
Before setting up the unit, verify that the following accessories are present:
- 2 x Wireless speakers (left and right speaker)
- 1 x AC/DC power adaptor
- 1 x 3.5mm AUX audio cable
- 1 x speaker base station
2. Power source
Unwind the power cord of the AC/DC adaptor to its full length; connect one end of the AC/DC
adaptor to the AC outlet (240V ~ 50 Hz), and the other end to the DC input jack on the rear
of the unit. Connecting this system to any other power source may cause damage to the
system.
3. Location of controls and indicators
A. Speaker Unit (Top panel)
A1. Volume button –:
Press the volume button repeatedly to decrease the main volume.
A2. Standby/on button:
Press the Standby button to turn the unit on, press it again to enter into standby mode.
(Note: Please make sure the speaker must be in the "OFF" position when the base is in
standby mode.)
A3. Volume button +:
Press the volume button repeatedly to increase the main volume.
10
All manuals and user guides at all-guides.com
A4. iPod dock connector.
B. Speaker Unit (Rear panel)
B1. AUX in jack (located on the back panel)
Connects an external source (3.5 mm socket).
B2. DC in jack (DC 9V in)
B3. CH1‚ CH2, CH3 (For wireless channel switch)
If interference is experienced, you can adjust the channel switch on the rear of the speaker
base station until the reception is improved.
C. Wireless speaker unit.
C1. Power switch on or off and volume control +/-:
Rotate the volume controller on (a blue light will appear behind the volume control) and
adjust the volume level as desired.
C2. Charging pin:
Place the right speaker on the right-hand side of the speaker base, and the left speaker
on the left-hand side of the speaker base. (an "L" or "R" marking is etched on the bottom of
each speaker)
11
Publicidad
