Measuring Range; Maintenance And Cleaning; Troubleshooting - Lanaform Baby Stone Manual Del Usuario

(Battery) power supply
Battery life
Level of protection against
solid particles and liquids
The thermometer is not water-proof

Measuring range

Measuring time
Area measured
Accuracy of measurement
Memory

MAINTENANCE AND CLEANING

- When you start taking a new measurement and in order to ensure accuracy and
good hygiene, always clean the tip of the probe with a cotton bud moistened with
alcohol. Wait for two minutes before taking the temperature again.
- Use a soft, dry cloth to clean the body of the thermometer. Never use a rough
towel and never immerse the thermometer in water or other liquids.

TROUBLESHOOTING

Anomalies
1. The screen
constantly displays the
temperature gauge as
too low "Lo"
2. The screen
constantly displays the
temperature gauge as
too high "Hi"
3.The low-battery sym-
bol « » appears
on the screen
4. The screen constant-
ly shows "Err 1"
Version 1 du 01/03/2016
3V continuous (1 «CR2032" lithium battery)
+/- 1000 measurements (in normal use)
IP 22
35 to 43°C
5 seconds
Area where temperature is taken is between
the eyebrows and roots of the hair.
± 0.2 °C (< 35.5°C) ± 0.1°C (35.5°C -> 42°C)
± 0.2°C (42.1°C -> 43°C)
Last measurement displayed when
switched on
Possible reasons Solutions
a) Make sure that a) Clean the probe with a
the tip of the probe soft, dry cloth or cotton bud
is clean moistened with alcohol.
b) The temperature b) Wait until the "
taken is below 35°C symbol appears and start the
(95°F) operation again
a) Make sure that a) Clean the probe with a
the tip of the probe soft, dry cloth or cotton bud
is clean moistened with alcohol
b)The temperature b)Wait until the "
taken is more than symbol appears and start the
43°C (109°F) operation again
The battery is low Replace it with a new battery
The temperature -Start the operation again
shown is beyond once the
the thermometer's "
detection limit the screen
-Put the thermometer in the
room for 30 minutes and then
start the operation again
"
"
" icon appears on