Tabla de contenido
Publicidad
Maximum power function:
• In this function you can set the operating time, but you can not adjust the temperature, since it is fixed.
• Press "Preset tiempo". The display will start blinking.
• Press "+ or -" to adjust.
• Once the time has been set, it will be fixed in a few seconds. The display will stop blinking.
• You can stop the operation by pressing "Pausa".
• To resume, press again.
• It must be taken into account that the device will automatically switch off after passing the time shown in the
display once pressed "Pausa".
• To turn off the unit press and disconnect it from the network.
• If an error code appears on the display, refer to the table:
Trouble code
Possible Reasons
E0
- No pot/pan on the plate;
- Non-usable Pans on the plate.
- D iameter of Pot is smaller than 120 mm.
E1
- IGBT Electrocircuit mulfunction.
- I GBT sensor is in open circuit or in short
circuit.
E2
- T emperature sensor failure (in open circuit
or in short circuit).
e3
- A bnormal supply voltage: voltage too low
(<80V).
e4
- A bnormal supply voltage: voltage too
high (>280V).
e6
- P late surface temperature too high.
- E mpty pot/pan heating leads to too high
temperature.
E7
- Thermal resistor doesn't work.
- When E3 or E4 appears, device will automatically stop heating but do not shut down.
- When other Trouble Code appear, device will automatically stop heating and shut down.
You could press function to restart the device and eliminate the Trouble Code.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, unplug the appliance from the mains and wait until the plate is totally cold.
• You can clean the body with a slightly dampened cloth.
• To clean the plate it is enough to use a slightly dampened cloth with soap. You also can clean the plate with
special products to clean vitro ceramic plates.
• If there are some hard residues you can use a scraper suitable for vitro ceramic hobs.
• Do not use abrasive or chemical products, metallic scourers, and such may deteriorate the surfaces.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
01 manual jata VIN145.indd 13
Solutions
Put suitable cooking utensils on the plate.
Please contact the supplier or go to a
qualified service center.
Please contact the supplier or go to a
qualified service center.
Please check power supply, power on after
power supply is back to normal.
Please check power supply, power on after
power supply is back to normal.
Please wait for some minutes until the cools
down.
Please check pot/pan.
Please contact the supplier or go to a
qualified service center.
13
27/03/17 12:34
Publicidad
Tabla de contenido
