Step C - Install The Filter Cartridge; Step D - Turn On Water, Check For Leaks And Rinse Carbon Fines; Filter Cartridges; Filter Cartridge Life - AEG FFS2 Guía De Uso Y Cuidado

1. Use a tube cutter to cut the end of tubing square.
2. Inspect the end (2-3 cm) of the tubing to be sure there are no nicks, scratches or other rough spots.
If needed cut the tubing again.
3. Push tubing through the collet and all the way into fitting. Full engagement is 1.9 cm length of tube into
the fitting.
push in fitting
foam plug
Remove and discard foam plugs
To Disconnect Tubing:
1. Push the collet inward and hold with a finger while pulling the tubing out.
collet (depress to remove tubing)
tubing

STEP C - INSTALL THE FILTER CARTRIDGE

1. Remove the small plastic shipping cap from the open end of the filter cartridge.
2. Install the cartridge onto the water filter head assembly, as shown in Figure 6. Turn cartridge to the right
to tighten.
STEP D - TURN ON WATER, CHECK FOR LEAKS AND RINSE
CARBON FINES
1. Open the shutoff valve(s) that you closed at the beginning of this installation.
2. Open the filtered water faucet to purge air from the system. When the water runs smooth, with no bubbles
or spurting, close faucet and check installation for leaks.
3. Open the filtered water faucet and let water run for 10 minutes to rinse out carbon fines.
All manuals and user guides at all-guides.com
Tubing correctly cut and connected
end of tubing round and smooth,
with no cuts, nicks or flat spots
correct full 1.9 cm engagement
Incorrect partial engagement
FIG.4
40

FILTER CARTRIDGES

FILTER CARTRIDGE LIFE

Taste and Odor Cartridges: A taste and odor cartridge contains activated carbon. When new, open the
filtered water faucet and allow fine, carbon particles to purge from the cartridge. Flush for 10 minutes. It is
recommended to replace filter cartridge every six months of use. There are several variables that determine
how long a cartridge will last. These include:
1. How much water you use, and
2. How much sediment, taste and/or odor, or other unwanted substance, is in the water.
Use the following information as a guide. However, no matter which type of cartridge you are using, you
will know it is time to replace them when you first notice the return of the unwanted sediment, taste
and/or odor in your water, or when the flow diminishes or stops.
AEG Undersink Full Flow Water Filtration System model AEGFFS2 with replacement element AEGFFF2
has a capacity of 7570 liters (2000 gallons) at a rated service flow of 7.6 liters per minute (2.0 gallons per
minute).

FILTER CARTRIDGE REPLACEMENT

NOTE: There is no need to shut off the water supply when replacing the filter cartridge.
1. Turn filter cartridge to the left to remove cartridge from the filter head.
2. Dispose of the cartridge in a proper manner.
3. Install new cartridge. Turn cartridge to the right to re-attach to the filter head.
Taste and Odor Cartridges: Taste and odor cartridges contain activated carbon, a black powder.
When new, open the filtered water faucet and allow fine, carbon particles to purge from the cartridge.
Flush for 10 minutes.
Turn filter cartridge to the left
to remove from head
Turn filter cartridge to the right
to attach to head
head
filter cartridge
41