Publicidad
MIXER REAR PANEL
1. POWER CONNECTOR
Connect the supplied power cable here.
2. VOLTAGE SELECTOR
Please ensure the correct voltage for your region
is selected.
3. SPEAKER OUTPUT
When using only one speaker, use a 4- 8 Ω
speaker".
SPEAKER REAR PANEL
1. INPUT
Connect the Speaker Output of the mixer here.
2. LINK
Connect this output to the input of another 8-16
Ω passive speaker.
SETUP
In order to correctly setup the system please use
the following steps.
1. Ensure that you have positioned the speakers far
enough apart to achieve an accurate stereo field
and place the mixer in the middle.
2. Insert the speaker cables into the speaker output
at the rear of the mixer.
3. After checking that master and channel volumes
are turned fully down, connect your microphones
and instruments to the appropriate channels on
the mixer.
4. Connect the mixer to the mains using the
provided IEC power cable and switch on.
5. Gradually increase the volume of the master
control and each channel until you reach the
desired level without introducing distortion.
Please note: It is strongly recommended that
you install your speakers onto tripod stands to
achieve maximum dispersion. When positioning
microphones avoid placing them directly in front of
the speakers to minimise the risk of feedback.
1
INPUT
1
8
2
3
LINK
2
Publicidad
