Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Direct
sunlight
may
affect
the acrylic
coating
and heat sources
may
increase
electrical
consumption.
Extreme
cold ambient
temperatures
may also cause the
appliance
not to
perform
properly.
Allow 2 inches
of
space
between
the
water
dispenser
and the
wall
which
allows
proper
air
circulation.
•
Plug the
appliance
into
an
exclusive
properly
installed-grounded
wall
outlet.
Do
not
under
any circumstances
cut
or
remove
the
third (ground)
prong
from
the power
cord.
Any
questions
concerning
power
andlor
grounding
should
be
directed
toward
a
certified
electrician
or
an authorized
Products
service
center.
This
water
dispenser
is not recommended
for outdoor
use.
Do
not
locate the dispenser
in area
where
the
temperature
may fall below freezing
(32
0
F).
Keep
area around
dispenser
free of dust and
dirt.
Keep the
reserve
supply
of water
bottles
away
from
excessive
heat and
light.
Never
unplug
the
water
cooler,
except
for
maintenance.
Before
Using
Your Water
Dispenser
Before
connecting
the
appliance
to the
power
source,
let
it
stand
upright
to approximately
2
hours. This
will reduce
the
possibility
of
a
malfunction
in the cooling
system
from
handling
during
transportation.
The water dispenser
is pre-cleaned
at the factory
but the
reservoir
and water
lines
must
be flushed
with
fresh water
before
use
as follows.
Keep
the
unit
unplugged.
Fill water tank with tap water full to
capacity
.Wait for
5
minutes
until
water settles.
Slide
child safety button
the push the hot water
faucet
until
water
comes
out,
and then
stop.
Proceed
to drain
the
water
from
the faucets
until
no more
water
remains.
Drain
any water left
in
the tank by
opening
the
water drain
plug
located
on the bottom
until
it drains completely.
Proceed
to close the
drain
cap.
Also
make sure
both
faucets
are
released
completely.
Place the water bottle on
the
water
intake;
allow
water
to stand
for approximately
one
minute.
Push both water
faucets
to insure water flows from both
faucets,
then release
both
faucets.
Plug
dispenser
into
the electrical
outlet.
Turn
power switch
ON
(at the rear).
Now
you
are ready to use your
water
dispenser.
ATTENTION:
If you do not plan to use
the
water
heating
function
for
more then two
or three
days,
we recommend
that you turn off
the
hot
water
function.
•••WARNING.
IMPROPER USE OF
THE
GROUNDED
PLUG CAN
RESULT
IN THE
RISK OF
ELECTRICAL
SHOCK. IF THE POWER CORD IS DAMAGED,
HAVE IT REPLACED
BY
AN AUTHORIZED
PRODUCTS SERVICE
CENTER.
3
OPERATING YOUR WATER DISPENSER
Electrical
Connection
This
appliance should be properly grounded for your
safety.
The power cord of this appliance is equipped
with
a
three-prong plug which mates
with
standard three prong wall outlets to minimize the
possibility
of
electrical
shock.
Plug the appliance into
an
exclusive properly installed-grounded
wall
outlet.
Do not
under
any
circumstances cut or remove the third
(ground)
prong
from
the
power
cord.
Any questions concerning
power andlor grounding
should be
directed toward
a certified
electrician or an authorized
Products
service
center.
C
This appliance requires a
standard
120 Volts A.C. 160Hz electrical outlet with three-prong ground.
The cord should be secured behind
the
appliance and
not
left
exposed or
dangling
to
prevent
accidental
injury.
Do not use an adapter plug with this
appliance.
Do not
use an
extension cord
with
this appliance.
If the
power
cord is
too
short,
have a qualified
electrician or service technician
install
an
outlet
near
the
appliance.
Steps To Replace Water
Bottle
'"
Use a clean cloth
to
wipe off
neck of
bottle.
d
Remove
cap,
if there is
one
on.
"
Insert
the
water
bottle
on the water intake
over
reservoir opening
so it
settles properly on
it.
"
Wipe off
any water,
which may have
splashed
on dispenser
top.
Note:
The hot
water faucet has a child safety
guard
attachment
CARE AND MAINTENANCE
•
Unplug the power cord from the wall outlet before
cleaning.
Wash the
inside of
the reservoir with a warm water and baking soda
solution.
The
solution
should
be
about 2 tablespoons of baking soda
to
a quart of water.
The
drip
tray and water faucets should be cleaned with
mild
detergent
and
warm
water.
TAKING DISPENSER
OUT
OF SERVICE
If
the
water
dispenser
will
not be used for
a
long period
of
time, unplug the power cord from the wall
outlet.
Drain
the water through the
faucets.
Drain
the water from the
tank
by removing
the plug
from
the
bottom of the
dispenser.
PROBLEMS
WITH
YOUR WATER
DISPENSER?
You can solve many common
water
dispenser
problems
easily,
saving
you the cost of
a
possible
service
call.
Try the suggestions
outlined
below
to see if
you can
solve
the
problem
before
calling
the service
center.
4
Publicidad
Tabla de contenido
