Publicidad
Idiomas disponibles
Idiomas disponibles
Place the self-tapping screws down into the pocket hole and drive with a cordless
drill until tight. Your joint should be tight, flush and extremely strong.
Select the Right Screw
Recommended Screw Length for Joinery
Material
Thickness
1/2" (12mm)
5/8" (16mm)
3/4" (19mm)
7/8" (22mm)
1" (25mm)
1-1/8" (29mm)
1-1/4" (32mm)
1-3/8" (35mm)
1-1/2" (38mm)
Step 4: Plugging the Pocket Holes
Place a plastic plug into the drilled hole, swab some glue inside, then sand the
surface.
Tips for getting the most out of your pocket hole tool:
For safety, clamp parts to a work surface before drilling pocket holes.
**NEVER HOLD THE TOOL AND PARTS IN YOUR HAND WHILE DRILLING.**
Use a corded electric drill with a speed of 2000 rpm or higher for drilling pocket
holes.
Use a cordless (battery) drill/driver with an adjustable clutch feature to drive
screws.
GB
Screw
Length
1" (25mm)
1" (25mm)
1-1/4" (32mm)
1-1/2" (38mm)
1-1/2" (38mm)
1-1/2" (38mm)
2" (51mm)
2" (51mm)
2-1/2" (64mm)
6
Timber position
Setting
1/2" Mark
5/8" Mark
3/4" Mark
7/8" Mark
1" Mark
1-1/8" Mark
1-1/4" Mark
1-3/8" Mark
1-1/2" Mark
Publicidad
