FrostEmily PRISMA 200 TN Instalación Y Uso página 7

6. CONTROLS
The appliance features adjusting controls, located at the front of the cabinet.
2. Refrigeration switch:
on the internal lights.
display the temperature inside the cabinet.
5 "SET or P"
Press Key once to display the temperature set-point, which can be changed by pressing
6 "UP" 7 "DOWN"
button or
7. CHECKING CORRECT OPERATION
Check that: 1.
The plug is connected. . The refrigeration unit switch is switched on (green light on).
3
. The thermometer shows the desired temperature for the goods to be stored.
exposed to direct sunlight or to high-powered lamps. . The room temperature does not exceed that in
which the appliance is designed to work normally, i.e. +25°C, 60% r.h. (climatic class 3).
appliance must be correctly filled, without overloading the shelves and with sufficient space for correct
cold air circulation.
8. INTERNAL CLEANING (EVERY 15 DAYS)
1.
Switch off the appliance.
accessories with a sponge dipped in water with a little sodium bicarbonate. Dry with care.
9. REPLACING THE INTERNAL LIGHTS
1.
Switch off the appliance.
3.
Undo the screws fixing the upper lamp socket.
from the upper lamp socket.
7
protective cover. . Replace the fluorescent tube.
10. REPLACING THE DOOR'S MAGNETIC GASKET
1 2.
. Open the door. Take hold of the magnetic gasket and pull it out of the frame.
gasket and press it firmly down all around (see figure 7).
Operator's guide
to switch on the refrigeration system.
Thermostat:
(see figure 5).
2
5
2
. Open the door and remove the refrigerated goods. . Wipe the sides and
2.
Remove the plastic cap, of the bulb to be replaced, from the roof.
4.
Detach the fluorescent tube with its protective cover
5.
Remove the tube from the lower lamp socket.
8.
Refit all parts in reverse order (see figure 6).
7
1. Light switch:
to adjust the temperature inside the cabinet. A)
4.
The appliance is not
3
6.
Remove the transparent
to switch
3. Thermometer:
to
N.B.:
the
3.
Insert the new
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO