Bauhaus Torino AJ150 Manual De Instrucciones página 12

own, unless constant supervision is provided.
The product must be installed upright on a flat,
dry surface after you have secured the 4 legs
with the screws provided.
Operation
The voltage of the power source must comply with the specifications on the ratings plate
of the heater. Devices marked with 230 V can also be operated at 220 V. Before use it is
imperative to ensure that the installation location corresponds to the requirements of the
safety instructions.
Note: When the heater is turned on for the first time, a slight, harmless odour can develop.
This odour develops due to the heating up of the inner heating elements. Provide sufficient
ventilation.
Note: Your heater is fitted with a safety device that will switch off the heater in case of
overheating. If the heater stops working, turn the heater off and inspect inlet and outlet for
blockages. Unplug the appliance and wait at least 10 minutes for the protection system to
reset before attempting to restart the heater. If the safety device still switches the heater
off and prevents the heater operating, take the heater to your nearest service center for
inspection and repair. Attention: Before restarting the heater, it must be unplugged for at least
10 minutes.
Switching the flame simulator on/off
Note: You can also switch the flame simulator on when you are not using the heating function.
• Set the ON / OFF switch [5] to position I.
• Set the ON / OFF switch [5] to position 0 to turn the flame simulator off
12