Uline H -1346 Manual De Instrucciones

H-1346, S-13699, S-13700
π
S-13701, S-15562, S-15563
S-19192
CABLE SEALS
Figure 1
Figure 2
Figure 3
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTALLATION
1. Be sure doors are properly closed and keeper bar handles
are properly latched.
2. Grasp cable seal by the case with the long end pointing up.
3. Insert long end of cable through hasp. (See Figure 1)
4. While grasping case with one hand, feed long end of cable
down through opening in the locking device with other hand
until a substantial length of cable protrudes. (See Figure 2)
5. Grasp the cable with one hand and case with the other.
Pull on cable tightly to minimize loop in cable. (See Figure 3)
NOTE: A slight twist of cable could be required if cable
catches exit hole.
NOTE: For maximum security, the cable must be pulled
through case as far as possible to minimize loop. Body
must be tugged downward with a minimum of 10
pounds of force to set seal.
NOTE: To remove, cut staked side.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0721 IH-1346