GB │ IE
■
Start-up
Inserting/replacing the batteries
Move the On/Off switch 6 to the "OFF" position.
♦
Open the battery compartment 7. To do this,
♦
press on the arrow marking on the battery
compartment cover and, at the same time, push it
downwards.
♦
Insert two type AAA/Micro batteries, as shown in
the battery compartment 7.
Close battery compartment 7.
♦
Assembly (see figs. A–C)
The appliance is suitable for doors/windows with
hinges on the right or left. Operating two magnets 5
with only one alarm device 1 is not possible. The
alarm device 1 and the magnets 5 are attached
using the self-adhesive strips on the rear side. The
surface to which the self-adhesive strips are affixed
must be clean, free of grease and dry. Remove the
protective film from the self-adhesive strips and affix
the alarm device 1 to the frame of the window or
door. Attach the magnets 5 parallel to the alarm
device 1 on the door window casement or the door
panel. The alignment mark 4 on the magnet 5 must
match up with the alignment mark 3 on the alarm
device 1. With larger window casements or door
panels, you can compensate the height difference
between the alarm device 1 and the magnet 5
using the additional self-adhesive strips.
NOTE
►
When the door or window is closed, the distance
between the alarm device 1 and the magnet 5
must not be greater than 15 mm!
Activate/deactivate alarm function
Push the On/Off switch 6 to the "ON" position.
♦
The alarm function is now activated and the alarm
will sound if the door or window is opened.
Move the On/Off switch 6 to the "OFF" position
♦
to deactivate the alarm.
Cleaning/storage
CAUTION
►
To avoid irreparable damage, ensure that
no moisture penetrates the appliance during
cleaning.
♦
Clean the appliance with a soft, dry cloth.
♦
If you decide not to use the appliance for a long
period, remove the batteries and store it in a clean,
dry place away from direct sunlight.
4