Cleaning And Maintenance - Bionaire BAP1700 Manual De Instrucciones

AIR QUALITY PARTICLE SENSOR
The AuTO feature uses the particle sensor to cycle
between 1, 2 and 3 speeds, based on surrounding
indoor air quality. To use this feature:
1. When air purifier is off, press the AuTO button.
• The button will illuminate and the air purifier will
turn on to auto mode.
2. When air purifier is on and set at any manual
mode speed, press the "auto" button.
• The button will illuminate and the air purifier will
run in auto mode.
SETTINg THE TIMER MODE
You may set the timer so it automatically turns off
when the desired time has elapsed:
1. press the TImeR ( ) button until you reach the
desired number of hours you want the unit to
operate (2, 4, 6 or 8).
• The number of hours selected will light up and
remain illuminated on the control panel.
• When time is up, the air purifier will beep 3
times and turn off.
2. To CANCeL the timer, press the TImeR button
until TIMER indicator lights are off. You may also
cancel the timer operation by turning the power
button off.
CLEANINg AND
MAINTENANCE
CLEANINg THE PERMANENT FILTERS
The peRmANeNT filters are designed to never
need replacement. However, we recommend regular
cleaning for optimal performance.
• every few weeks, check the condition of the
filters.
• After approximately 3 months of operation, a
Filter Clean Indicator will alert you to clean the
filters before further use.
To clean the filter:
1. Turn off and unplug the air purifier.
2. Remove the air inlet grill by pulling on the tab.
3. Remove and examine the foam pre-filter.
• If it has collected dust or lint, remove and wash
it in warm soapy water. Rinse and drip dry
thoroughly before placing it back into the gril inlet.
4. Check the condition of the peRmANeNT filters
and remove if dirty.
5. Clean the peRmANeNT filters.
• Using your vacuum cleaner, run the brush
attachment along both sides of the filters and
clean between the pleated layers (Figure 2).
IMPORTANT: Do not use water, household cleaners
or detergents to clean the PERMANENT filters.
The filter may appear discolored, even after
vacuuming. This is normal and does not affect
performance in any way—a new filter is not
necessary. If the filter becomes damaged during
cleaning, visit the nearest Authorized Service
Center to purchase a replacement filter.
RESETTINg THE FILTER INDICATOR LIgHT
AND REINSTALLINg THE FILTERS
Complete after reinstalling the filters and/or resetting
the filter indicator light.
NOTE: A hang tab and filter clips ensure the filters
attach properly.
1. unplug unit from wall.
2. Make sure the hang
tab is securely in place
(FIGURe 3). Align the
clip on the top of the
filters with the rails on
the side of the of the unit
Gently slide the filters
onto the rail (FIGURe 4).
3. place air inlet grill (with the
foam pre-filter) back
onto unit securely.
4. After replacing the filters,
completely close the unit
and plug it into the wall
outlet.
5. With the unit on, RESET
the Filter Indicator (
by inserting a small
object (such as a pin or
paper clip) into the hole
below the filter Indicator
Light ( ).
6. Hold the button down
for 5 seconds.
7. The light will now turn off.
4
figure 2
figure 3
figure 4
figure 5
Reset
)
Button