Artecristal INTELIGENTE Manual De Instrucciones página 5

1. Assemble the 2 profiles (B) with the 2
profiles (C), joining them with all the
screws (N), obtaining a structure of the
screen. It is important to mount both sides
at the same time, and join them with the
corner pieces (W).
2. Fit a wall profile (D) to each of the sides
of the structure created previously.
Important DO NOT screw at the moment.
3. Put the entire structure in the hole where
it goes to the screen, in order to mark its
position on the wall. After marking where
the holes go, we remove the structure of
the hole.
4. Make the holes in the wall at the marks
made in step 4, insert the plugs (S).
5. Put the silicone on the wall in all the hole
where the screen goes, and on the floor.
6. Place the assembled structure in the hole,
gluing it to the wall and the floor with the
silicone applied in step 5.
7. Screw the structure to the wall with the
screws (M) and washers (R). Then put the
trim (Q).
8. Anscrew the profiles (B and D) with the
screws (O) and washers (R). Then put the
TRIM (Q).
9. The 2 fixed crystals (T2) are placed on
each side of the structure with the gasket
(E). We also put the stops (L) in each
corner of the fixed windows, both upper
and lower.
Mampara Inteligente Angular
10. We put the upper (J) and lower
(K) wheels to the sliding windows
(T1) (which
Attention: To
lower wheel (K), press the button
on the upper part of the wheel.
Once the wheels are on the sliding
windows (T1), mount them on the screen.
11. The rubbers (G) are placed one on each
fixed pane (T2) and one on each sliding
pane (T1).
12. With the partition doors closed, the
doors must be adjusted so that they close
properly without gaps in the closing area.
For this, the lower wheels are adjusted by
means of the upper button on the wheel.
13. Once the screen is correctly assembled,
and with the doors closed, we put the
stops (U and V) in the following position.
14. We put the handles on the doors.
OPTIONAL
It is convenient to seal the screen with silicone
between the profile and the wall so that the
water can escape through that area.
If the area is sealed with silicone, DO NOT USE
the shower within 24 HOURS. In the case of
use, it is very likely that leaks may occur.
are still unassembled)
correctly insert the