Targa GW 84 B1 Manual De Instrucciones E Indicaciones De Seguridad página 51

WARNING! When assembling the barbecue, make sure that the heads of the
screws always point outwards. This allows you to prevent injuries caused by
protruding screws.
Below are instructions on how to assemble the barbecue in eight steps, including diagrams. Set
aside the required individual components and assembly materials.
Step 1
 Hand-screw the two slat holders (18) to the wheel legs (15). Use the bottom hole of the slat
holder (18) and the middle hole of the wheel leg (15) to do this, see diagram. You will need a
screw (21), a washer (25) and a nut (23) in each case.
 Fasten the reinforcing bars (17) to the wheel legs (15). You will need a screw (21), a washer
(25) and a nut (23) for each one.
 Now fasten the reinforcing bars (17) to the slat holders (18). You will need a screw (21), a
washer (25) and a nut (23) for each one.
 Screw the wheel legs (15) and mounted slat holder (18) to the left side of the charcoal basket
(6). To do this, use the top hole of the wheel legs (15).
Please note: The three holes for assembling the wind guard in the charcoal basket (6) must
be facing the back. For each wheel leg (15) you will need two screws (21), two washers (25)
and two nuts (23).
 Now tighten all the screws.
GW 84 B1
English - 49