Uline H-7805 Manual De Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Determine desired tray location and mark a line
1" above the bottom edge of board. Drill two 5/16"
diameter holes in wall 5⁄" apart.
5. Push in two plastic anchors into predrilled holes. Place
tray mount over plastic anchors and secure with two
CS screws. (See Figure 4)
Figure 4
Bottom
of Board
Tray Mount
CS Screw
6. Place aluminum tray in the front slot of tray mount
and align the holes. Secure aluminum tray to tray
mount using two Phillips tray screws. (See Figure 5)
Figure 5
Aluminum Tray
Phillips Tray Screw
7.
Measure down 3/4" from the top line and draw
another line that is parallel. Measure in about
6" from each side and install top four wall mount
brackets using four CS screws. (See Figure 6)
NOTE: Leave the top wall mount brackets
pushed up.
Figure 6
Top Edge
6"
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 3 OF 9
INSTALLATION CONTINUED
Wall
Tray
Mount
5⁄"
Line
Plastic
Anchor
Line for
Board Mounts
Tray Mount
CS
Wall
Screw
Mount
3/4"
Bracket
1-800-295-5510
uline.com
8. Apply self-adhesive pads to back of board. Peel
one side of the backer from the pad and apply to
the board as shown. (See Figure 7) Then peel the
other side before mounting on the wall. Carefully
position the panel left to right before applying
pressure against the wall.
Figure 7
12"
Self-Adhesive
Vertical Mount
Self-Adhesive
18"
9. Place the glass board on bottom wall mount brackets
and screw in the four wall mount bracket outer caps
to secure. Tilt the glass board back and push down
the top wall mount brackets onto the board's top
edge. Secure board in place by screwing in the four
top wall mount bracket outer caps. (See Figure 8)
Wall Mount Bracket
Figure 8
Wall Mount Bracket
Outer Cap
Center
12"
Pads
Pads
18"
Horizontal
Center
Mount
Wall Mount
Outer Cap
Bracket
Glass
Board
Wall Mount
Bracket
0919 IH-7805

Publicidad

Tabla de contenido
loading

Tabla de contenido