Tripp-Lite SmartRack SRSEHOOD Instrucciones De Instalación página 2

1. Remove the Roof Panel
Models with Screws Securing the Roof
1
Remove the four 4 screws (2 on front, 2 on back) that
attach the roof panel to the unit.
1
2. Installing the Drip-Resistant Cable Access
Housing
1
Remove one of the rubber sealing plugs from the top rear of the
enclosure by pushing it out from inside of the unit.
2
Using the included M4 x 8 mm pan head machine screws and toothed
washers (4 of each), fasten the screws into each of the threaded
holes.
Tripp Lite has a policy of continuous improvement. Product specifications are subject to change without notice.
(continued)
Photos and illustrations may differ slightly from actual products.
1111 W. 35th Street, Chicago, IL 60609 USA • tripplite.com/support
2
Lift the roof panel from the enclosure.
2
1
2
2
21-04-128 93-3ECE_RevA