Connecting The Timer - Orbit 57865 Manual De Instrucciones

CONNECTING THE TIMER

Connect the timer to the valve after you
have programmed it. This timer will only
operate with DC solenoids that have been
included in the package. Replace any
original solenoids on valves connected to
the timer with these DC solenoids.
Note: Included solenoid adapters may be
necessary depending on the specific valve.
1. Make sure the main timer unit is fully
inserted into the docking bay.
2. Twist on the protective timer cover tight
enough to ensure a waterproof, dirt-
proof seal. Do not over-tighten.
Connecting Timer to Valve
1. Attach timer clip to valve solenoid.
2. Remove plug from the receptacle
marked "1" on the bottom of the timer.
3. Insert wire connector into the receptacle
marked "1" on the bottom of the timer.
Ensure that the connector fully seats
8
into the receptacle.
4. Attach timer to timer clip.
5. Rotate dial to OFF. Wait 60 seconds to
allow the timer to close all valves.
6. Rotate dial to AUTO and replace cap.
Step 1
Step 3
Step 5
Step 2
Step 4
Step 6