Audio Connections; Electrical Connections - SKP Pro Audio VX-02 Manual Del Usuario

crossover. To operate the VX-02 in stereo 3-way operation, follow the top row of markings horizontally along the
length of the VX-02 for stereo 2-way operation of the VX-02 use the second row of markings directly above the
connectors. For mono 4-way operation of the VX-02 use the markings directly below the connectors. The
connectors not used in the selected mode are marked "not used". This designation applies only to that mode of
operation.
The VX-02 is marked in a similar way: for stereo 2-way operation use the markings above the connectors. To
operate the VX-02 in mono 3-way mode use the markings below the connectors. The connectors which are not
used in the selected mode are marked "not used". This designation applies only to that mode of operation.

AUDIO CONNECTIONS

·Before connection anything to the crossover,, make sure it is not connected to any power source.
· Be sure that the source device(equalizer, compressor, nixing console, etc.) for the VX-02 is turned off. Connect
the output(s) of the source device to the inputs of the crossover, following the rear panel markings carefully.
·Make sure that the amplifiers which will be used to drive your speaker system are turned off. Using the back
panel markings as a guide, use high quality cables to connect the amplifiers to the appropriate outputs of the
VX-02 ELECTRICAL CONNECTIONS
Ensure that your VX-02 crossover conforms to the AC power specifications in your area, by checking the marked
voltage spec on the rear of the unit. Never plug the incorrect voltage into your
Input:
Connectors:
Type:
Impedance:
Max Input Level:
CMRR:
Output
Connectors:
Type:
Impedance:
Max Input Level:
PERFORMANCE:
Bandwidth:
Frequency Response:
Signal-to-Noise:
Low Output:
Mid Output:
High Output:
Dynamic Range:
THD+Noise:
Interchannel Crosswalk:
All manuals and user guides at all-guides.com
1/4"TRS
Electronically balanced/unbalanced, rf filtered
Balanced > 50kΩ,unbalanced>25kΩ
+22dB typical, balanced or unbalanced
>40dB, typicality >55dB at 1 kHz
1/4"TRS
Impedance-balanced/unbalanced, RF filtered
balanced 220Ω,unbalanced100Ω
>+21dBu Balanced / unbalanced into 2kΩ or greater
20 Hz to 20 kHz, +0/-0.5 dB
< 3 Hz to >90kHz, +0/-3 dB
Ref: +4 dBu, 22 kHz measurement bandwidth
Stereo Mode:
> 94dB
> 91dB
>106dB, unweighted, any output
<0.004% at +4 dBu,1 kHz
<0.004% at +20 dBu,1 kHz
< -80dB, 20Hz to 20 kHz
Mono Mode:
> 94dB
> 93 dB
> 91dB