Cleaning And Maintenance; Troubleshooting - Kampa 300 Instrucciones De Montaje Y De Uso

I
NOTE
• The canopy comes with general purpose pegs. These
will be suitable for many sites but for some types of
ground special pegs will be needed. Ask your dealer.
• Drive the pegs at a 45° angle away from the canopy into
the ground.
• Peg each guy line in-line with the seam it starts from.
Keep the following tips in mind while setting up the canopy:
• The figures provide a general overview of the set-up. The actual set-up
will vary slightly based on the model of canopy.
• Get help. The set-up is easier with more people.
• Thread the poles through the outer sleeves.
• After standing the canopy upright, check the corner pegs and re-peg
if necessary.
• Peg the guy lines so that the canopy is under tension without distort-
ing the shape.
• Check the guy lines from time to time to ensure adequate tension, if
necessary use the runners to adjust.
Set up the canopy as follows:
1. To protect the canopy from dirt and damage, lay down a ground-
sheet or footprint before unpacking.
2. Unpack the canopy.
3. Separate and identify the different components.
4. Proceed as shown to set up the canopy (fig. 1, page 3 – fig. 7,
page 4).
Dismantling the canopy
A
NOTICE! Material damage
Do not use force when dismantling the canopy. Otherwise
you might damage any material.
1. Reverse the set up procedure.
2. Push the poles out of the sleeves, do not pull.
3. Ensure that all parts are clean before packing in the carry bag.
4. If the canopy is wet or damp, dry fully as soon as possible.

Cleaning and maintenance

A
NOTICE! Damage hazard
• Do not use sharp or hard objects or cleaning agents for
cleaning.
• Do not use alcohol based materials, chemicals, soap
and detergents for cleaning.
• Remove bird droppings and tree resin as soon as
possible to avoid permanent damage to the material.
1. If necessary, clean the product with clean water and a soft brush.
2. Apply impregnation against water and UV radiation before each trip.
Storing the canopy
I
NOTE
• Fully set up the canopy for cleaning.
• Choose a sunny day for cleaning to ensure the material
will dry thoroughly.
1. Clean the canopy.
2. Air fully and ensure the canopy is totally dry before packing away.
3. Store in a well ventilated dry place.
6

Troubleshooting

I
NOTE
• During first exposure to water there may be some
moisture at the seams. Through this moisture the threads
will swell and fill the holes that are created in the sewing
process.
• A fully equipped spare parts kit should include:
–
–
–
–
Problem
Water leak
Rip in the fabric
Shock cord connecting the
poles has broken
Pole has broken
Condensation
All canopies suffer from internal condensation if one or more of the
following conditions apply:
• high air humidity
• high ground moisture
• a drop in temperature
Severe condensation can run down the inside of the roof and drip off ties,
tapes and other internal fittings and can be mistaken for leaking.
➤ Increase ventilation by opening doors and/or windows.
➤ Install a waterproof groundsheet.
Disposal
➤ Place the packaging material in the appropriate recycling waste bins,
wherever possible.
➤ Consult a local recycling center or specialist dealer for details about
how to dispose of the product in accordance with the applicable dis-
posal regulations.
Warranty
The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see
kampaoutdoors.com/store-locator) or your retailer.
For repair and warranty processing, please include the following docu-
ments when you send in the device:
• A copy of the receipt with purchase date
• A reason for the claim or description of the fault
4445103583
Waterproofer
Repair tape and repair solution
Silicone spray for the zippers
Spare pegs
Solution
➤ Check for leaky seams, damaged
tapings and moist areas.
➤ If you cannot find any leaks, see chapter
"Condensation" on page 6.
➤ If you find any leaks, apply seam
sealant.
➤ Use repair tape to seal the fabric.
➤ Have repairs carried out by an
authorized specialist.
➤ Purchase a replacement shock cord.
➤ Replace the shock cord.
➤ Use a metal peg as a splint by taping it
to the broken pole.
➤ Purchase a new pole.
EN