Important Safety Instructions For Battery Chargers - Porter Cable PC1800AL Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

90550832 PC1800AlREVISED with pcxmvc charger added
SYMBOLS
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class II Construction
(double insulated)
..............safety alert symbol
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for
battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using battery pack.
WARNING:
CAUTION:
designated Porter-Cable batteries. Other types of batteries may burst causing
personal injury and damage.
CAUTION:
the power supply, the charger can be shorted by foreign material. Foreign materials of
a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup
of metallic particles should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the cavity. Unplug
charger before attempting to clean.
• DO NOT attempt to charge the battery pack with any chargers other than the ones in
this manual. The charger and battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than charging designated
Porter-Cable rechargeable batteries. Any other uses may result in risk of fire, electric
shock or electrocution
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of
damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire, electric shock, or electrocution.
• An extension cord must have adequate wire size (AWG or American Wire Gauge)
for safety. The smaller the gauge number of the wire, the greater the capacity of the
cable, that is 16 gauge has more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each individual extension contains at
least the minimum wire size.
• Do not place any object on top of charger or place the charger on a soft surface
that might block the ventilation slots and result in excessive internal heat. Place
the charger in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• Do not mount charger on wall or permanently affix charger to any surface. The
charger is intended to use on a flat, stable surface (i.e., table top, bench top).
• Do not operate charger with damaged cord or plug — have them replaced immediately.
All manuals and user guides at all-guides.com
4/27/09
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
................earthing terminal
../min or rpm ....revolutions or reciprocations
per minute
Shock hazard. Do not allow any liquid to get inside charger.
Burn hazard. To reduce the risk of injury, charge only
Under certain conditions, with the charger plugged in to
6
8:14 AM
Page 6

Publicidad

Tabla de contenido
loading

Tabla de contenido