Publicidad
KRAIBURG maxiBOARD
Requirements:
mats are already
installed in the
stalls or positioned
correctly
You will need this:
marking:
measuring:
or
or
additionally for 2-1/2" (6 cm) mats:
plastic board (height 1-1/4" (3 cm))
!
When installing KRAIBURG stall mats and maxiBOARD together, please note:
Initially follow the installation instructions for the stall mats keeping in mind the front edge of stall mats
and the maxiBOARD are fixed at the same time!
Exception: first completely fasten the WELA LongLine stall mat roll and then install maxiBOARDs.
1
position maxiBOARDs
fit the profiles into each other and move them loosely flush to the mat's edge
Use of plastic boards as shim (for 2-1/2" (6 cm) stall mats):
Appropriate installation may differ due to local conditions.
Therefore the manufacturer is not liable for installation!
1
concrete area:
• level
• smooth
• clean
cutting:
drilling and installing:
or
or
or
In order to heighten the maxiBOARDs,
shim with plastic boards
INSTALLATION INSTRUCTIONS
maxiBOARDs:
Installation Temperature:
minimum 41°F (5°C) to maximum 86°F
(30°C) (be sure internal temperature of
mats falls within above range)
fastening components:
• 3/8" x 4" LDT steel anchor
• 1/2" fender washer
(or fastening components with at least the
same resistance and durability)
or
60
50
40
86°F
30
20
41°F
10
0
Do not
!
press!
KRAIBURG maxiBOARD - US - 2/2019 - I
Publicidad
