Assembly - HydroOxy 1000 Manual Del Usuario

Specification:
•
Rated voltage：220-240V
•
Rated frequency： 50Hz
•
Output power：1500W (+5%,-10%)
•
Water tank capacity： 360ML
•
Waterproof level：IPX4

ASSEMBLY

NOTE: Each steam mop is 100% tested in the factory to ensure product performance and safety. When assembling your new steam mop for the first time you may
notice water residue inside of the unit.
! WARNING: Before attempting any of the following operations, make sure that the appliance is switched off and unplugged and that the appliance is cold and
contains minimal or no water.
Spread Holder:
•
Round the holder along spindle until click to fix holder.
•
Press spindle button 1, turn the holder, the holder can become folded state.
Attaching the Steam Head:
•
Slide the bottom end of main body onto the steam head M until Steam head Spindle 5 Clicks into place.
•
The steam head M can be removed from the Main body by pressing salient point on the steam head Spindle 5.
Attaching a Cleaning Pad:
•
Because of barb design at the bottom of steam head M, just place a micro-fiber cleaning pad L to steam mop head, they
can bond.
•
Place the front of your shoe onto the cleaning pad removal tab and press down firmly.
Attaching Carpet Gilder:
•
Press the micro-fiber cleaning pad L with main body to Carpet glider O by vertical pressure，until it is into place.
•
Place the front of your shoe onto the cleaning pad removal tab and press down firmly, carpet glider will remove from
steam head.
www.HydroOxy.com
All manuals and user guides at all-guides.com
Page 5 of 39