Altec Lansing PT7031 Guia Del Usuario página 5

Remote Control
This section describes the function of each control on the remote
control used to control the PT7031.
Note: You can also control other components using the remote control
once you set the appropriate remote control codes. See the
"Programming device remote control codes" section of this manual.
9
8
10
1. POWER Use to toggle between On and Standby modes.
Increases or decreases the overall volume level
2. VOL +/–
of the unit.
Move to highlight items in the on-screen display
3.
and OK (OSD) setup menu. Press OK to confirm.
Sets the remote to control the PT7031 as
4. AUDIO
opposed to DVD, TV, SAT/CAB or AUX devices.
Press to cycle through inputs – DVD, TV/SAT,
5. INPUT
AUX, DVD digital, TV/SAT digital and AUX digital.
6. MUTE Press to turn off or restore sound.
7. FRONT, CENTER, Increases or decreases the volume level of the
REAR +/– LEVELS individual channels for the system.
8. BASS Enhances low frequency or bass output.
Use to select virtual or stereo mode of system
9. MODE depending on the sound modes available from
your audio source.
Press to enter or exit the on-screen display
10. OSD
(OSD) setup menu.
All manuals and user guides at all-guides.com
1
2
3
4
5
6
7
5
Installing the PT7031
This section provides guidelines for locating and installing your new
PT7031.
The PT7031 creates a realistic surround sound experience from a single
unit by using Dolby's Virtual Speaker technology. While placement is
less critical than similar systems, the following general guidelines
should be followed where possible to ensure best sound quality.
• Avoid placement where furniture or other items would obstruct the
grill area.
• Center the PT7031 below the TV so that dialogue appears to be
coming from it.
• Locate your PT7031 and TV in the center of the wall.
• Listening position should be no less than six feet (2 meters) from the
PT7031.
• Avoid placing the PT7031 on or near surfaces that may vibrate.
Locating the PT7031
The PT7031 can be placed on a suitable level surface or mounted on
the wall using the supplied wall mounting bracket.
Safety Notes:
• Be sure to leave adequate ventilation space – at least 2 inches
(50mm) above the PT7031
• We do not recommend installing this unit so that it is directly on
the floor.
• The PT7031 weighs approximately (18.1 lbs.) (8.2 kg). Be sure to
secure it where it will not fall and where it is out of the reach of
children.
• Do not install this unit directly above a cathode-ray tube (CRT) TV as
stray magnetic fields may distort the TV.
Wall Mounting
If you are mounting the PT7031 on the wall please follow these steps:
1. Determine a suitable wall location for mounting the wireless speaker
within reach of the unit's AC cord.
2. Position and level the supplied metal mounting bracket in the desired
location on the wall.
3. Being careful to avoid any items (wires, pipes, etc.) hidden inside the
wall secure the metal mounting bracket using appropriate fasteners
for the application. If you are unsure which type of fasteners to use
or are unable to determine if there are items within the wall that
could be damaged please consult a licensed contractor.
4. Place the speaker on the mounting bracket by aligning the two
buttonholes on the rear of the speaker with the posts on the
mounting bracket. Check to make sure the wall mount bracket and
speaker are securely fixed in place.
2 inches
(50 mm)
PT7031