Sleep Mode - Best Buy EasyPhone 3.5 Manual Del Usuario

User Manual
All manuals and user guides at all-guides.com
Installation of Micro SD and SIM Cards
1- Open the rear housing of the unit.
2- Once the battery has been taken out, install the optional card Micro SD
(sliding it to the right) and lifting up the metal seal) and the SIM cards (sli-
ding them to the left). Make sure that the card and phone connections coin-
cide. Make sure you lower the metal seal of the Micro SD card and slide it
to the left.
3- Install the battery, making its connectors coincide with those of the
phone.
4- Close the rear housing of the unit.
Note: You can configure your cards by accessing the application Adjus-
tments > SIM Card administration. This phone may take up to two cards/
phone numbers simultaneously.
Charging the battery and first use of the phone
Before using the phone for the first time, we would recommend you to to-
tally recharge the battery. With this in mind, connect the transformer of
the unit to the electrical mains and then the Micro USB connection to the
phone. The battery charging level will be displayed on the screen. Once
the battery has been charged, keep the Power button pressed in to turn the
unit on.

Sleep mode

After the phone has changed to sleep mode, the screen will go off and
lock. To use it again follow these steps:
1. Press the power button to turn on the screen.
2. Drag the lock icon to the right to unlock the screen. If you have confi-
gured an unlock pattern or key, you must draw the unlock pattern or enter
the password to access the main interface.
37