Procom Heating MNSD2TPA Manual De Funcionamiento E Instalacion Del Propietario página 4

1. Do not place Propane/LP supply tank(s)
inside any structure. Propane/LP supply
tank(s) must be placed outdoors.
2. Heaters 10,000 Btu/Hr or more shall not
be installed in a bedroom or bathroom.
3. This heater needs fresh air ventilation to
run properly. This heater has an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS shuts down the heater
if not enough fresh air is available. See
Air for Combustion and Ventilation, pages
8 and 9. If heater keeps shutting off, see
Troubleshooting, page 24.
4. Keep all air openings in front and bottom
of heater clear and free of debris. This will
ensure enough air for proper combustion.
5. If heater shuts off, do not relight until you
have provided fresh, outside air. If heater
keeps shutting off, have it serviced.
6. Do not run heater:
• Where flammable liquids or vapors are
used or stored.
• Under dusty conditions.
4
All manuals and user guides at all-guides.com
SAFETY
7. Before using furniture polish, wax, carpet
8. Always run heater with control knob at
9. Do not use heater if any part has been
10. Turn off and unplug heater and let cool
11. Operating heater above elevations of
12. To prevent performance problems, do
www.usaprocom.com
cleaner, or similar products, turn heater off.
If heated, the vapors from these products
may create a white powder residue within
burner box or on adjacent walls or furniture.
PILOT/IGN, LOW (1) or HIGH (5) locked
positions. Never set control knob between
locked positions. Poor combustion and
higher levels of carbon monoxide may
result.
under water. Immediately call a qualified
service technician to inspect the room
heater and to replace any part of the
control system and any gas control which
has been under water.
before servicing. Only a qualified service
person should service and repair heater.
4,500 feet could cause pilot outage.
not use propane/LP fuel tank of less than
100 lbs. capacity.
200218-01A