Uline H-6493 Manual De Instrucciones página 2

5. Insert 7/8" screws through the frame and seat as
shown. Use screwdriver to secure. (See Figure 5)
Figure 5
6. Insert 1  ⁄" screws through frame and seat. Use
screwdriver to secure. (See Figure 6)
Figure 6
1. Insert each end of the seatbelt into the innermost
slots of the back of the seat. (See Figure 8)
Figure 8
2. Weave each end of the seatbelt through
the remaining slots in the back of the seat.
(See Figure 9)
Figure 9
PAGE 2 OF 9
INSTRUCTIONS CONTINUED
SEATBELT INSTALLATION INSTRUCTIONS
7. Seal screw openings with covers. Use a rubber
mallet to apply. Wear safety glasses during cover
application. (See Figure 7)
Figure 7
NOTE: Check that all screws and fittings are
correctly and tightly fitted before and during
use.
3. Each end of the seatbelt should stick out the back of
the seat as shown. Pull ends to secure. (See Figure 10)
Figure 10
WARNING! The child should be secured in the high
chair at all times by the restraining system. The tray
(not included) is not designed to hold the child
in the chair. It is recommended that the high
chair be used only by children capable of sitting
upright unassisted.
WARNING! Prevent serious injury or death from
falls or sliding out:
• Always secure child in the restraint.
• Always keep child in view while in high chair.
• Never leave child unattended.
• Do not use the high chair if any part is
broken, torn or missing.
• Do not use high chair unless all components
are correctly fitted and adjusted.
• Be aware of the risk of open fire and other
sources of strong heat, such as electric bar fires,
gas fires, etc., in the vicinity of the high chair.
0421 IH-6493