Bernina 50 Manual Del Usuario página 10

Attention
1. Preparation for sewing
> Pin pieces together in the
usual way, basting whe-
re necessary. Insert pins
horizontally when sewing
fabrics with
stripes.
10
In order to avoid a collision of the needle with the walking
foot during switching on, the needle must be positioned
with the hand wheel in its highest position.
2. Machine settings
> Choose the stitch desi-
red and set stitch width
and length in the
mal
horizontal suit the fabric. Test sew.
> Exception:
Reverse feed stitches. The
maximum stitch length
setting for these stitches
is 3.
nor-
way, adjusting to
3. Sewing small curves
> Do not turn fabric while
sewing but stop every few
stitches with the needle in
the work, lift the foot and
turn the work slightly.
> The Walking Foot can be
used with or without the
seam guide.