Chapter 2 Installation; Hardware Installation; Software Installation - Acard AEC-6293M Guia De Inicio Rapido

Chapter 2 Installation

2.1 Hardware Installation

Please follow the 7 steps to install AEC-6293M Please follow the 7 steps to install AEC-6293M
1. Be sure that the system power has been off. 1. Be sure that the system power has been off.
2. Open the chassis of Mac. 2. Open the chassis of Mac.
3. Insert AEC-6293M into an available PCI slot. 3. Insert AEC-6293M into an available PCI slot.
PCI Slot
4. Screw the AEC-6293M onto the chassis
5. Connect AEC-6293M with a SATA/ IDE hard drive via SATA/ eSATA/ IDE cable and connect
the power cord to the hard drive properly.
6. Clost the chassis and power on the system.
7. If you have external eSATA system, connect AEC-6293M with external SATA system via eSATA
cable.
Notice: The Serial ATA cable is used to transfer data in very high frequency. It is suggested no to
connect and disconnect offten, or the connector could be damaged.

2.2 Software Installation

No extra driver is required during the installation. The OS will detect and install the driver
automatically.
You may check information about the adapter from "System Profile".
All manuals and user guides at all-guides.com
7
AEC-6293M Manual