MAXIMUS SPL12-06A1W4 Instrucciones De Montaje página 3

Installaion
Step 1 (Fig. 1)
Determine desired mouning locaion on a wall or an eave.
Step 2 (Fig. 2)
Unlock the locking switch (D).
Step 3 (Fig. 3)
Remove mouning plate (C) from ixture by turning plate clockwise.
Step 4 (Fig. 4)
Remove the exising light ixture and install the mouning bracket (H) with the stamped word
"FRONT" facing away from the juncion box.Use the mouning bracket screw (L) to ix the
mouning bracket. Firmly pull on the mouning bracket to verify it is securely mounted to the
juncion box.
Step 5 (Fig. 5)
Use connector (I) to complete wiring, and use ground connecion screw (M) to connect ground
wire with mouning bracket (H).
Step 6 (Fig. 6)
Use M5 screw (J) to link the mouning plate (C) with mouning bracket (H), the screw should not
be ixed too ight.
Step 7 (Fig. 6)
Adjust the mouning plate (C) to make sure the air bubble in air level is in the middle. Link the M4
screw (K) on mouning bracket (H). Tighten M4 screw (K) and M5 screw (J).
Step 8 (Fig. 7)
Align the botom edge of the power supply compartment (B) with the botom edge of the
mouning plate (C). Insert the conducing post on power supply compartment (B) into the holes
on mouning plate (C). Tilt and lock the locking switch (D).
CAUTION: Read how-to secion before turning power back on at circuit breaker or fuse.
All manuals and user guides at all-guides.com
Fig. 1
Fig. 2
Fig. 3
Fig. 4 Fig. 5
Fig. 6